4 Things You Can Use for Cutting Practice with Your New Japanese Sword (and Some Things You Should Not Use)

So you’re the proud owner of a new Japanese sword such as a katana or odachi – congratulations!

If your new sword is battle ready – which means it is made from an appropriate steel, is tempered, and has a traditional, full tang (nakago) like a historical Japanese sword, it can be used for training, and this includes cutting practice.

With that said, here are 4 things that make excellent targets for cutting practice with a Japanese sword (or any sword) followed by a few that are decidedly not good ideas

Tatami Mats

Traditionally, tatami mats, which are made of rushes, have been rolled up and used for cutting practice. They offer just the right balance of weight and mass to present a good target, and they require reasonably good form to cut properly, without tearing or messing up the roll of the mat.

They can understandably be a little hard to find, and may not necessarily be cheap, so if you need a practice alternative, consider getting some of those cheap straw beach mats, roll a few of those up, and give it a go.

Water Bottles

Water bottles can also make excellent cutting practice targets. They’re perfect because the plastic used in most water bottles resists a blade, but the water adds mass.

The long and short of it is that you need a very fine edge and good form to slice through a water bottle evenly. If you don’t have those two things, you’ll cut part of the way through or just knock the bottle out of the way.

But if you’re looking for the best of the best – get a milk jug. They are made with a relatively soft plastic polymer called HDPE, which slices like butter. Fill them with water and slice them up – it’s a joy to do so.

Fruit

Fruits can also make excellent targets, and you can start with larger fruits like pumpkins, squashes and watermelons, stepping down to smaller fruits like apples and tomatoes as you become more proficient.

Just one word of caution, here. If you do use fruit for cutting practice with a traditional Japanese sword, make sure you clean the blade off immediately after using it. The acids in most fruit juices will make short work of any finish on the surface of the blade and can force a patina that you might not want, if not worse, rust the blade.

Pool Noodles

Lastly, if you need a cheap and accessible cutting target that definitely won’t break the bank, won’t make a mess, and won’t damage the blade,  consider getting a bunch of pool noodles.

They’re also good targets for experienced swordsmen because they’re very light and low density, which can actually make them pretty hard to cut through if they’re freestanding.

What Shouldn’t You Use?

Now let’s cover a few things you shouldn’t cut with your sword: avoid wood, stone, hard plastics, and anything that’s more or less harder than a big fruit. Also, never drive the blade of your sword into the ground. This will dull it quickly, may damage it, and can expose it to salts or other substances that will scratch or corrode the blade.

Here for a New Japanese Sword?

If you’re here for a traditional Japanese sword that’s a work of art and reflective of Japanese culture, take a look at what’s available over at True Swords. They carry a variety of battle-ready swords, and among them are katana, odachi swords, wakizashi, and tanto, among others. Take a closer look at their website and get in touch with them if you have any questions.

For more information about Otf Knife and Rengoku Sword Please visit: True Swords.

Leave a Reply

Your email address will not be published. Required fields are marked *

Busniess

Understanding the Quality and Value of a Lab-Grown Diamond Tennis Bracelet

A lab-grown diamond tennis bracelet offers lasting elegance, everyday comfort, and exceptional craftsmanship in a single piece of jewelry. While its timeless appearance captures immediate attention, its true value comes from careful construction, quality materials, and thoughtful design. Understanding these details helps you appreciate what makes a bracelet beautiful, durable, and enjoyable to wear for […]

Read More
Busniess

Roller-Delayed PCCs: 9mm vs. 10mm

That one extra millimeter in caliber makes a serious difference in cartridge performance between the 9mm Luger and 10mm Auto. If you’re tossed up between a roller-delayed PCC chambered in one of these, here’s what you should know about them. Where the 9mm Excels If you’re considering a roller-delayed PCC chambered in 9mm, here are […]

Read More
Busniess

The Checklist Facilities Managers Use Before Ordering PTAC Units

Facilities managers who’ve been through a commercial HVAC procurement cycle before don’t start with a brand name. They start with a list. Ordering PTAC units for a multi-room property involves more variables than most buyers expect, and the teams that get it right aren’t necessarily the ones with the biggest budget. They’re the ones who […]

Read More